Goodman 2 Ton 17.2 SEER2 8.2 HSPF2 Two-Stage Heat Pump Condenser ComfortBridge R-32

Goodman's most efficient heat pump — year-round comfort from one premium unit. The Goodman GLZT7CA2410 is a 2-ton, 17.2 SEER2 / 8.2 HSPF2 two-stage heat pump that delivers Goodman's highest efficiency in both cooling and heating from a single outdoor unit. Operates in two stages to match the load more closely, reducing energy consumption during mild conditions while still providing full capacity when needed — up to1 17.5 SEER2 / 8.2 HSPF2. With ComfortBridge™, CoolCloud™, Copeland ComfortAlert™, and SmartShift® time-delay defrost technology — this is the most advanced 2-ton heat pump condenser in the Goodman lineup. 

Why Homeowners and Contractors Choose the GLZT7CA2410:

• 17.2 SEER2 cooling efficiency — approximately 25% more efficient than the 13.4 SEER2 federal minimum
• 8.2 HSPF2 heating efficiency — high-efficiency heat pump heating for mild to moderate climates
• 2 Ton / 24,000 BTU capacity — ideal for small to medium homes between 1,000–1,200 sq ft
• Two-stage Copeland UltraTech scroll compressor — low-speed operation most of the time for quieter, more efficient heating and cooling
• Superior active dehumidification — two-stage technology removes more moisture during cooling season
• SmartShift® time-delay defrost technology — ensures quiet, smooth, and reliable defrost transitions without temperature spikes or disruption
• ComfortBridge™ communicating technology — self-optimizing system intelligence for maximum year-round efficiency
• CoolCloud™ Bluetooth app — smartphone commissioning and diagnostics for your contractor
• Copeland® ComfortAlert™ diagnostics — proactive compressor fault monitoring
• Compatible with Goodman GTST Connected Thermostat — smart home integration
• Diagnostic indicator lights with storage of 6 fault codes
• Color-coded terminal strip for non-communicating setup
• Efficient two-speed ECM condenser fan motor
• High-density foam compressor sound blanket — whisper-quiet operation
• Copper tube / enhanced aluminum fin coil (5mm)
• Factory-installed bi-flow liquid-line filter drier — bi-directional protection in both heating and cooling modes
• Factory-installed suction-line accumulator — protects compressor during heating operation
• Factory-installed compressor crankcase heater — cold-weather reliability and extended compressor life
• Factory-installed high-capacity muffler — quieter refrigerant flow
• High and low-pressure safety switches
• Factory-installed transformer
• Ambient temperature sensors
• R-32 refrigerant — one-third lower GWP than R-410A
• Factory pre-charged for 15 ft of tubing
• Easy-access gauge ports and service valves with sweat connections
• Steel louver coil guard with rust-resistant coated screws
• Top and side maintenance access panels
• Heavy-gauge galvanized-steel cabinet with Architectural Gray powder-coat finish — 500-hour salt-spray approved
• Hurricane-ready construction — meets 2020 Florida Building Code requirements
• Heating and cooling — pairs with compatible R-32 indoor unit with RDS
• AHRI Certified and ETL Listed
• Made in the USA

⚠️ R-32 refrigerant requires compatible indoor equipment with RDS. Not compatible with R-410A. TXV required on indoor unit.

⚠️ Backup heat source recommended for extreme cold temperatures. If using a gas, LP, or oil furnace as backup, a heat pump compatible thermostat is required.

Specs:

• Tonnage: 2 Ton (24,000 BTU)
• SEER2: Up to 17.2
• HSPF2: Up to 8.2
• Refrigerant: R-32
• Compressor: Two-Stage Copeland UltraTech Scroll
• Fan Motor: Two-Speed ECM
• Coil: 5mm Copper Tube / Enhanced Aluminum Fin
• Voltage: 208/230V — 1Ph — 60Hz
• MCA: 15.6 Amps
• Max Breaker (MOP): 20 Amps
• Operation: Heating + Cooling
• Certifications: AHRI, ETL

Warranty: 10-year limited parts warranty with online registration within 60 days of installation.